Discussion: DPF removal EGR on the Alfa 159 2.4 JTDM

Originally Written by Errecinque

I learned thanks to the forum then it is fair to share to those who do not know. 1DE432 display 8-bit take it from 1 to 2 . 1e46ee in 16-bit carry from 400 to val max 65535. And the dpf is as if there were

Hello Errecinque, this speech is also good for the 159 1.9 jtdm 150 hp?

Originally Written by Errecinque

I learned thanks to the forum then it is fair to share to those who do not know. 1DE432 display 8-bit take it from 1 to 2 . 1e46ee in 16-bit carry from 400 to val max 65535. And the dpf is as if there were

Originally Written by cinqueturbo

.

Originally Written by Julez

Many thanks.I feel at the end of the week.I must do the csf with ecuscan?before writing the file in the ecu with mpps,I have to give the checksum of the modified file in the ecm?

Tube fap finally arrived. Is it okay if I proceed as follows:

1) load the file with the switch-ff as recommended from a friend errrcinque
2) can I change the mechanical part
3) changing the oil and resetto errors of waste oil with ecuscan

Should I do another?


Thanks

Originally Written by ultimo000

Tube fap finally arrived. Is it okay if I proceed as follows:

1) load the file with the switch-ff as recommended from a friend errrcinque
2) can I change the mechanical part
3) changing the oil and resetto errors of waste oil with ecuscan

Should I do another?


Thanks

I would say that it is all correct. When you enter the diagnosis after you have loaded the map controls the setting that is without dpf and clogging up to 1000%