Printable View
Hello all, I have removed from the control unit Bosch/Psa of my peugeot 207 this eprom : 95160wq as you advise me to proceed to the clear?
I should munirmi of the programmer, the new file, and prog for the diagnosis right?
Thanks and congratulations to all!
Go to the section presentations before posting on the forum and read the rulesQuote:
Originally Written by ElvisPg
Sorry for the departure in the fourth, but I did take from passion, after having removed the ms I have discovered a world
How can I start to read the data in the eprom?
Post the contents of 95160, the number of airbag control unit, the year of the vehicle, etc...
Then let's see what you can do.
To read the eeprom you need a programmer, you can start with a zp20 of silancode that reads the soick 8 low cost, and excellentQuote:
Originally Written by ElvisPg
Thanks for the help, I do the reading! I downloaded the datasheet of the eeprom I try to extract the data with my programmer for PIC, if you don't do it purchase
the one recommended by you
For the moment, to place the data drive and centr. :
- Peugeot 207 year 2008
- Bosch - 0 285 010 112 Bosch 96 635 934 80 - 95160wq
Tomorrow prover? to read the file.
Thanks!
The eye that if it does not support 100% the kind of integrated, it may delete the data of the memoryQuote:
Originally Written by ElvisPg
Ok Ross, thanks for the warning be? attention otherwise goodbye data...
If you make it different, you could buy a willem
Before connecting my eeprom I did a simulation on the Pc of the circuit and I was able to read a file that is preloaded in the 95160. Not just to succeed? solder the memory
physics on the circuit do? the upload of the file. But in the memory which data are saved apart from those relating to the crash?
you are in the 95160 data relating to the crasch and all the restQuote:
Originally Written by ElvisPg
Guys I finally read the contents of the memory
- Peugeot 207 year 2008
- Bosch - 0 285 010 112 Bosch 96 635 934 80 - 95160
here is the clear,let us know!!
Thank you so much for the help, to download the file, I have to get to 80 message right?
you're right, you can't download,you have to have 80 posts!!Quote:
Originally Written by ElvisPg
A strange curiosity?, I could use this same file on another machine with the same airbag ecu?
if the ecu is the same!! :)Quote:
Originally Written by ElvisPg
And once the file is loaded, or if the light does not turn off(touch iron...) which tool can I use for diagnostics?
Thanks
any diagnosis of the generic or specific of the houseQuote:
Originally Written by ElvisPg
I could ask you again for the support on these two files "clean" both relating to the same ecu. Why? differ?
Thanks
For diagnostics you can use autocom/texa/bosch!! :)
C'? a procedure to reconnect the airbag control unit?Keep disconnected the battery and plug in the ecu, etc, etc,
Let? a first test with one of the two files that I cleaned with tachosoft while I wait to download your own, the
what I don't understand ? as I said the difference between the two files that I attached. Differ a lot in the initial part
Thanks
I tried to write to one of the two files I posted anything, light still on, tomorrow bring? a diagnosis. Or the file nn ? correct
or the belt tensioners that I did mount not go well. In the case you could disable it from the bin file?