presentation

hello everyone I present are sisco mechanic that deals with industrial vehicles, together with a colleague, we changed the unit of his car, and from there was born a great thirst for knowledge,I hope that I do not want if I remain a little but before I say something I would like to expand my knowledge, and I hope they will not cancel my membership. greetings to all

Welcome...everyone tries to contribute to what can...

welcome where are you from???

Greetings sisco where are you

welcome sisco,some info + about you??

hello physical and welcome,but is that really your name sisco?
in addition, we would like to know how old you are and where you are,no cancel your membership of course you have to do your part.

Welcome...

welcome also from my side.

hello and welcome!

hello everyone my real name ? francis, a native of puglia
but transplanted from almost twenty years in the province of mantua by almost 15 years in the industrial vehicles, I have a autocom a elm 327 a galletto 1260 and mpps, but use them mostly for diagnosis and resets the service of friends and acquaintances, and up to now, we have edited and written a little, I say we because? as I have already? said in the presentation we I and a colleague of mine where I try to keep up with necessary software and he tries to change the maps.

welcome sisco, you'll see you'll be good

hi all sorry if I write here but not in the section dedicated to the autocom but the discussions about him are so many that I don't know which is which ? for this question, in any case, please tell me you that right ,in practice today I did a diagnosis with a seat ibiza 1400 with light engine is on, the fault code was n 16825 autocom said -ventilation system storage tank; the air flow is not correct - permanent, I took a look at the canister and hoses near, everything seemed in place, I cleared the fault code tested the camera and the lamp is not ? pi? on,the diagnosis was that the valve was working I tried to do a test of the ventilation with the autocom, after the launch of the test autocom makes me see the valve in the percentage working after for? instead of telling me if ? ok, or not ok, as it says in the guide if it is there with the circle spinning until you lose the communication you tell me something about it thanks

the discussions are so many and then you can open your own directly here does not make much sense.

Hello welcome.............

Sorry! I have presented ....I am a young enthusiast of the electronics over time ****** it dedicates a bit for the engines, of course, I am writing to the forum because alone I don't go very far, thank you all for the help that you can give me in case of any problems

ok thanks for letting me answer, I have never made an active part of any forum and, therefore, are a p? disoriented, I also have to say that the regulation I have read a p? to the fast, then mea culpa, can I ask if you can take a look at a map made for an audi a4 for my brother, or if you can tell me who I can ask for, always you can do, and I also have to find out how you f? send

You need to open a discussion in the beginners section
Then write the post and in the advanced ec where to attach the file ke, you must first zip

thanks fidofido