Alfa 147 edc15c7 the injection times of doubt

Hello everyone I am new to the forum-it's a wonderful that are writing but until now I'm only limited to read and do various tests on my machine..looking a bit here and there I've brought you surge the various and iq of 80 mm3 raised the limiters rail up to 1400 bar the two bits to 1350 l car pushes good not to smoke so much I made a logo and injects actually 80 mm3, however, I would like to understand how to change the break time and learn how to make a thing well done..In practice, I should be tabular to climb the curves back and create the break new up to 80 mm3? I hope someone can help me I do not have very clear ideas..thanks in advance.David

you almost explained by only..study the map times.
especially in the last break point...

Hello munro, thanks for the interest, I've followed many of your discussions! In practice, from what I understand I do a new one for 80 in the last line in the penultimate one from a 75 and then others call in with the ones from the 70's, that I already have up in the bottom right? And then I go back to the beginning of time and a suitable break point to tell them to read up to 80 that now it is 70?

I know that I don't understand..the last row is that of 4500 rpm is to 0 that I have to leave it as is? And if the stopover the third, and the fourth row down should be overwritten by the fifth and the sixth non mi quadra..sorry but I do not understand

I too would like to figure out how to change the time of iniez

in fact, it may not be so, because from a negative value.instead, if riscali the load i.e. the entire column of the 100% goes in place of 95% that 95% goes to 90% and so on might work.hypothesis my

the times of the injections are the a and b axis are the speed of the engine, the other axis is the quantity of diesel injected and the numbers written in the table are the opening time of the injector.so what we see in tabbella as charged(100%) is actually 70 mg.

I understand what you mean I tried to riscalarle in that way but doing so at 1100 rpm I would have an increase of 300% so I think this is the right way..

Or I had also thought to bring the break at the beginning that is prior to the map time (that ori is 7003 if I'm not mistaken, and would correspond to 70 mm3) up to 8003 in this way I would have an increase in the percentage of 14.6 giving this increase to any single column, I'd get the time for 80mm3, but it seems to me too easy so..