cloning sid 804

You copied only the Flash..
the eprom?

hello nn I copied because it's usually for scodificare part of this type of ecu I just need the data flash.this if I'm not mistaken, the eeprom on the door from the opposite side to the processor right?

yes, but the data of the bsi ce them in the eprom then you'll need to copy the eprom

ok I try and I want to know

raises capacitors is the under

Don't be afraid to break the connections of the capacitors, bend until you memory easy to desolder, it does not break anything, just two supportini of plastic, then when you put the capacitors in their place will come back all ok.

Quote:

---

Originally Written by amen

Don't be afraid to break the connections of the capacitors, bend until you memory easy to desolder, it does not break anything, just two supportini of plastic, then when you put the capacitors in their place will come back all ok.

---

Up to a certain point, however, that by raising the capacitors and bend the pcb and then always with due policy

then I copied the data from either eeprom or flash, but it was the machine nn part I repeat I have them copied on a ecu with the same nm hw

Then must necessarily start, you enter the diagnosis?