Printable View
Good evening to you all! Regarding the checksum...
When I change a map ori, I'm going to save it, and in the windows of the right in the box, "the original file" and "modified" have the same number, but then if I exit the program, reentry, and I try to charge me two different numbers!!
How it works st? what??
if you use the ecm with the proper driver you should not have to worry about the checksum calculates him......? normal for you to leave different numbers why? all the times that you change something you have to recalculate the checksum, however, has this think about the program
Thank you! But also the example of the attempt of the map that I posted in the other discussion I did with the ecm, but a user told me that the check is not ? correct! I think as I read from the windows..
attention that the sw processing corrects the ck on all files, and in case that should be done by the programmer,with regard to the ck wrong may also depend on the sw cr...... that makes him sick.
I don't have Dawn if the sw is cr... or not honestly...
For this I have no doubt... How do I verify a check that correct??
Many thanks for your help!!
I do not understand what you mean by:
I don't have Dawn if the sw is cr...
That I don't know if the software is demo, crack, or other...
after tell us of that file ori you're talking about, that ecu ? ? edc 15 you have to calculate the checksum, the ecm if you see tells you the family of the checksum with the one in the windows above show that allows you to check to see if ? correct, while if you have a control unit, for example, edc16, the chk is calculated by the programmer, type mpps.
I'm doing tests, such as maps of a bosch m 3.8.3, which of course I can't find in the families of the check..
How do you have already? that said, do ? need to ricalcolarti necessarily the cks: depending on the type of programmer, these ? able diricalcolarlo at the time of the write-in control unit. Once loaded the software, as the last step, f? due cacoli and correzioniin mododachiudere correctly the flash.
Which programmer do you use to read/write to the ecu?
Hello
Marco