Opinion the Map Alfa 156 105hp

Hi all guys, I might have an opinion on this map is made by me?
Thanks

you pull up to 180?

Quote:

---

Originally Written by SandroMarciano

you pull up to 180?

---

No because

why? the rail ? at the limit, can? be that at that speed? gives you failure with the beach suddenly. the rest does no damage, mod quiet...

Quote:

---

Originally Written by SandroMarciano

why? the rail ? at the limit, can? be that at that speed? gives you failure with the beach suddenly. the rest does no damage, mod quiet...

---

Look, I don't think I've seen maps to the same drive that the rail ? increased by 7%.

what counts is not the percentage that matters but the maximum value, then I'm not talking about reliability?, but of recovery, caused by the fact that you have the last 2 curves of the time to 0, that relating to 1500bar and to 2000bar, then there are a bit scattered on the map that even the ones they send in the recovery.
The rail pressure does not increase the power, the council ? leave it original, or under 1400bar in a change to quiet like this

Quote:

---

Originally Written by SandroMarciano

what counts is not the percentage that matters but the maximum value, then I'm not talking about reliability?, but of recovery, caused by the fact that you have the last 2 curves of the time to 0, that relating to 1500bar and to 2000bar, then there are a bit scattered on the map that even the ones they send in the recovery.
The rail pressure does not increase the power, the council ? leave it original, or under 1400bar in a change to quiet like this

---

Can you tell me what are these bits scattered on the map?

07BD58 I found this, but I don't remember if there were other, you have to try to do a pull a 180 and see if the machine off (worn behind the diagnosis to remove the error). Of course you must also fill in the durve that I said to you that are missing.

Quote:

---

Originally Written by SandroMarciano

07BD58 I found this, but I don't remember if there were other, you have to try to do a pull a 180 and see if the machine off (worn behind the diagnosis to remove the error). Of course you must also fill in the durve that I said to you that are missing.

---

What curves?

Quote:

---

Originally Written by SandroMarciano

07BD58 I found this, but I don't remember if there were other, you have to try to do a pull a 180 and see if the machine off (worn behind the diagnosis to remove the error). Of course you must also fill in the durve that I said to you that are missing.

---

However, to address 07BD58 c'? the pressure of the rail, and in addition to giving the increases from 50 to load and 1500 rpm, I have not changed any bit