The council for the purchase of ODB2 to start

Quote:

---

Originally Written by tonybiond

I have to make a delta 2009 what do you say what do I have to use , but then the schedule that they come out with the bdm must be placed above the template, or to be welded

---

if' and' of 2009, you can' do from the OBD without any problems, even with the cock 1260, mpps, cock v53...
sa' you jig the schedule you support and if you haven't, you have to solder...

Good evening,
sorry if I'm intruding, I have a problem with the gallo2 v53 chinese clone bdm does not work for me;
there are two cables to one plate of about 10 cm, and the other of about 15 cm, ranging from the HW to the adapter and the adattaroe to the e xxx and connecting I do not read : I have been told that I have to reverse the wires to make it work instead of the original.... AND TRUE ! Bho !
to someone ? gi? happened and I pu? help .. Thanks in advance ..

Quote:

---

Originally Written by Peppino

Good evening,
sorry if I'm intruding, I have a problem with the gallo2 v53 chinese clone bdm does not work for me;
there are two cables to one plate of about 10 cm, and the other of about 15 cm, ranging from the HW to the adapter and the adattaroe to the e xxx and connecting I do not read : I have been told that I have to reverse the wires to make it work instead of the original.... AND TRUE ! Bho !
to someone ? gi? happened and I pu? help .. Thanks in advance ..

---

with this question you must be out of the question, you should open a discussion if you already? not c'? for your problem

how ever no one here recommends the kess v2?

A question, but the various colors of the adapters, what are they for?

It should be cos?
Green diagnostics ABS and power steering
Red diagnostic drivers
Yellow engine diagnostics

and you can interchange if necessary?

And the violet, what it is used for
.

Quote:

---

Originally Written by Peppino

Good evening,
sorry if I'm intruding, I have a problem with the gallo2 v53 chinese clone bdm does not work for me;
there are two cables to one plate of about 10 cm, and the other of about 15 cm, ranging from the HW to the adapter and the adattaroe to the e xxx and connecting I do not read : I have been told that I have to reverse the wires to make it work instead of the original.... AND TRUE ! Bho !
to someone ? gi? happened and I pu? help .. Thanks in advance ..

---

Hi all I think that if you stasse attentive to the explanations that there are in the folder that the document you might understand more? and anyway, if you have problems with the rooster, the problem is that we must buy with security, and especially do not aim only at saving why? then you are faced with a problem ir? big in my opinion..Or to unsolder and resolder the components that are missing or are wrong, and even of poor quality? therefore in the end be better to buy a good product spend a little more? but at least work with tranquility?..Then boh I do not know what some say.......In my opinion.

I had a bad experience with bdm 100, the flat cable was to the contrary ..***** o you should have in the my documents folder to the scheme to make various tests ....I always recommend before starting to take all the information possible. .