Printable View
You never learn, now that I think of it at first diagnosis with broken pump gave the error pump module, so you actually come back to feel the pump because of the message of the return of the can, in a normal pump ammeno failure directly to the control module that is change.oedenza to the coil of the pump, the ECU does not notice the failure.
Hi Ugo, you ? was called in phase from the pompista, as I said ori okay, even if to be a 180 hp and peppermint, will be for the wheel 18 and the traction four -, ? a machine 20 tons and passes
I think I should be mg....
the limit and 50-51.....
however, final fantasy x, the request from the pedal ? relative....
because then that request is "filtered" from various limiters...
the couple,fumes,etc...
therefore what counts and what the ecu sends to the "output" as required diesel...
if you exceed the 50-51 mg....size....
You go to act on the smoke limiter but I see the gi? that map exceeds 51mg, ammeno which that value is expressed in mm3, but I don't know, voltage ? safe given that the value is sent in the van and translated in Volts after
if you can help this is what is map to the same file.
thanks a lot hugh, then 6DD12 injection P. C. , I think it is not from the tap, I see that for every step it turns the maximum value ? always 9000, now I don't think I have ne mg ne mm2, the volt I suppose no, because the transmission ? in can, ammeno that does not give information on the can bus of the voltage, and would not pesno that you can overcome 9v, then, thinking of the bp and the second bp has maximum value 8100, I assume so is a percentage, maybe, but I'm not sure, it should get to 8200, then rpija of this map c'? also a limiter on the basis of the temperature begins on 6DC4A, your opinion? according to you ? touch is the map or ? only one map conversion, which should not be altered? I have to figure out the relevant ionterpretare values on this map and on the maps fumes
here is the latest map I made, let's try tomorrow, not today, and came, I datop a small increment to the map to 6dd12 to see if ? deleterious, or if it helps, I gave masx 1.5 degrees only at high flow rates of diesel for down payments, I have made 2 from try, this cdove I also found some limiters iq and the other the v7 with only map the pedal, lim torque and turbo, so try them all and 2 and I see where the problem lies
muy buen hole..
Quote:
Originally Written by tib
I invite you to read the rules,write in English, and especially to pass in the presentation section, thanks.