in fact, I usually edit only the values in the positive, and this I do in all of the maps where can I find negative values
Printable View
in fact, I usually edit only the values in the positive, and this I do in all of the maps where can I find negative values
Slut Zoxxa then seeing the map turbo and doing the conversion according to the calculations I have the fairy that I should come 3080bar :Or I did the math right? on 100% load 1300 rpm value ? 220 then 220*14=3080...but ? can? or am I that in my great ignorance, I understood one thing for another? why? seeing the original values at the load ? 192 then 192*14=2688...forgive my ignorance....
the calculation you have to deduct always 1000 mbar press atmospheric, I believe, so I think 2688 are 1688 cio? almost 1.7 bar....
among other things I wanted to ask the magi, but the conversion factor psi are you sure that is 14? no because for what it s? I 1 bar is equal to 14.7 psi....then the values are recalculated to 14,7 are still other....
to tell you the truth, 1 bar are 14.5037738 psi.
in several of the foreign forum I found how to info to multiply by 14
the correct test to do would be to get in the way with the original machine at full load, and see what is the value of the pressure turbo, then divide it by 14 and see if it corresponds to the maximum value in the map, otherwise you will have to divide by 14.5.
the 1.3 have the fairy that full charge to 1.7 kills...
So guys a piece of advice...do you say that ? better start the original turbo on the 1.3?
son pi? good with the electronics with the mechanical, I don't have all this knowledge on the limits of the turbines,for? for me, up to 1.8 you can't push in yet.
but that value and an overboost or mileage?
I do not know if ? of an overboost or mileage sincerely....the only thing that I understand ? that in my file ? too high..
but the limiter turbo to how much ? set from the ori??