Printable View
tell you how I proceeded;
I opened the map ori,I modified it in the table and saved.
After I opened the map and went to open the map limiter ,displayed in a table.I then clicked on the 2d ,(as shown in the figure),so would like to know the address 07886C corresponds to the ldc? I see pretty much a peak,as I have to interpret?? in case you want to close the egr, tabellere, how do I proceed and in 2d?
yes the address is correct,it is not a peak but a curve where there are axes that correspond to the rpm and load.
for the egr I close my "linearizzandola"that is put the maximum limit imposed by the map (in your case it is 183)then open in 2d, and inspect everything and see if there are peaks or voids. then, there is the map, mass air flow sensor 072348 that if you want the map and soft are not an expert, don't touch it,and then all the others..................
Quote:
Originally Written by frenk85
not is clear to me one thing,what should be the egr,on ecm2000 calls it "phase injection? or on ecm (with drivers of the same program) as he calls it???
Tomorrow I want to try to plug physically the egr with a plate,....it seems to make more...
I have learned that injection phase on the ecm corresponds to the egr valve, in my map I had as a max value 194,but on the 2d I had then a step to the end,I opted to bring all values to 183.
is correct?
I wanted to know why do those who opened the post and who has then replicated, we have had the delicacy to do that here we are in the rules section mahhh..........every way I move in the section beginners.
I noticed yesterday evening to find that the discussion that was not in the right section,but I have not given weight, the next time I will do this.
I didn't realize posting in the wrong place....
but now it's been moved discussion?
do not answer me no one?? help me!
what do you want to know?!?
I would like to know how is the map posted if the map soft can go , if I get some improvement in ****s performance, and if not, what and how should I further modify....
Thanks