Then I confirm that the same mapping with or without this map mod you feel the difference?? . But it should be increased on all the curves??Quote:
Originally Written by dariuccio
Printable View
Then I confirm that the same mapping with or without this map mod you feel the difference?? . But it should be increased on all the curves??Quote:
Originally Written by dariuccio
I say that with this map left ori the machine should not be as it should, I can do as an afr, multiply the higher value in the table for 0,001302.....
what do you think?
I tried to moddare the two-bit rail and the machine goes into recovery
I sincerely do not know what 06AC4A and I don't even know to what it refers, and the value ? 0
really? the bits 0 are the first two and the last two, I had already? but I don't understand what's the use, you have to raise even the first two or only the last?
I think the last two... however, expect confirmations ;) I am from a few weeks to hunt for the bits that just overtakes 1480 bar I turn off the car... that depends also from these two zeros? haha ;)
If you look at the axis of the Break see that the penultimate corresponding to 1500 bar, we have 0..so it might be..
therefore, in addition to the 2-bit value 775 we must also increase 064C4A?