Reading tour IAW59F with FGTechv53

fgtech v53 can read/write via serial to obd ?
the bench does not succeed...

in the tour you must read if the interface works, the problem ? only in the epilogue to the tour if not ? virgin, I have tried both with the ecu under and over the 100.

if, and under 100 serves a dedicated interface!!

under the 100 serves a dedicated interface to make it a virgin but not to read it, I made one last week to tour, read, coded and it can be programmed in the
scodificata with the proper tool and then programmed, I have the special tool to do these jobs but I wanted to try the cock with both ecu under and over the 100 to test reading and writing.

I understood for scodifica :))

to read there are problems with the cock, the laws both above and below the 100 the file ? good for mapping, but to write it, I write on the machine, or must be a virgin, for riverginarla under 100 only with tool, above 100 or tool or in the boot strap even with the cock with utility fiat clone, decode,

Quote:

---

Originally Written by giuseppe1374

to read there are problems with the cock, the laws both above and below the 100 the file ? good for mapping, but to write it, I write on the machine, or must be a virgin, for riverginarla under 100 only with tool, above 100 or tool or in the boot strap even with the cock with utility fiat clone, decode,

---

by mounting the ecu on the car, I can write it with his dump made the virgin with the dedicated software?

on the machine itself ? the ecu of that car you don't need to make it a virgin.

in fact, because it already has read the code and gives you the consent to read!!

then with fgtechv53 not c'? so do write to this ecu...