Dpf/egr opel meriva

Then the backup includes flash eeprom and mpc. The file to be able to write with mpps ? 1 mega the flash of the backup ? by two and then change the file from 2 mega fix the chcks the cuts with the ecm in a way that it will become a mega and I write with mpps

Quote:

---

Originally Written by MOT

Then I realized I was wrong to find the file, I found the same file with the hw and sw is the same but ends up with the BDM.fls.From how I understand this type of file is used to write bdm in the event of a fault, etc...
instead, I need the file for MPPS to write a serial port that has to be with the sw and hw are the same, not ? compatible to the bdm right?

---

correct, the file to write in the bdm ? complete, c'? instead of the one for mpps ? only a part of the part.

in practice, you need to read the flash and not the full backup as you have found

Ah, just figured out and then cut with the ecm and try to write,in the event that it crashes I have to rewrite it in the bdm!
However, the number of sw and hw of the ecu are these :
Marelli Hawdware Number : MAG 01246O204D
Marelli Software Number : 3422M167
Has anyone had problems with this type of ecu with MPPS ?

In the event crashes do not turn off the ignition and repeat the procedure with mode? recovery

Then if it crashes it crashes during the writing?In mpps c'? the mode? recovery?the cio? it puts in automatically?

No, you need to set you.. Sure you lock or writing the best it could

where do I find the command recovery,I can not find it in the menu?

Options speed? and selections slow

I tried to write it gives me the following error:
The encrypted File is not allowed? continue

That indicates?