Printable View
edc16 to write it after you have fixed via the serial port before you remove the e2p and doing a partial,and after you is to write ,or bdm (nothing bootmode)
edc15 after it is nailed , you can' do bootmode.. or unsolder the flash 29f200/400/800 and write it with a programmer type willem ,or scod partial/total e2p always dissaldandola and riprogrammandola and then writing it to the flash with the serial.
Ok thanks, saw that I got appointed as the willem, but only connects via parallel port? so it takes an old pc
willem and now dated, it was as an example.. cmq or pc provided with parallel or usb converter>parallel
on other forums I have read that even in the boot there are able to read the sirius32n in with fgtech2,
only without the boot ...but the file and size is 32kb ..so not useful for the socd total..
I read, though, that someone was able to read with a cable kkl and the sw DDT2000
I'm not sure on this ecu.
in fact, I wanted to do a total on this ecu but the only way ? disconnect the flash now I'm trying to put a socket and then do the tests without desoldering.....
The boot mode ? in practice mode? used to do the backup, if any, with the gallo 2 of the edc17 for example? The Cio? the boot mode ? what a tour, you open the ecu, then weld the pin, gets up and ends up l
what you say more? precisely, it's called boot mode tricore!!!Quote:
Originally Written by pitty
ok, but ? correct then all of us? I said? The Cio? the backup of the various control units is always in boot mode tricore? or the situation is different for other units?
P.S.
I believe that we have found here, is it frantik3? eh eh eh!!!
it is also here