first map bmw edc16

already that idiot I forgot.....*****o parts by request pedal..it seems to me that the ecm the call enrich colostrum in acceleration..this is the map the pedal, or the driver wish which is practically another not ? that your request for the diesel? in nm...and then in the Z-axis you're not directly in the diesel fuel, but request in the pair if the increase in for example the 50% load and 1500 rpm...of a tot you'll need to adegure also the various limitaori in the same way....
for the rest ask and you will be? given without any problems with this ? a forum where there are a few secrets and we share almost everything...

Oooh, finally, tomorrow I will change the map as you told me and the place

here is the new mod, this time I added a limiter, turbo, correct the rail pressure, the added torque limiter and limiter prex rail, in the pi? I have increased by 20% enrichment in acceleration from 50 to 100% starting from 1500 to 5000 rpm

I have just noticed you have made a mess on the prex turbo so I do not consider

for the moment, do not touch the press rail...
the twin-turbo bmw already traveling series to 1600 bar...
more than enough to get performances worthy of note...
system the press turbo and not depart too much from the low gains with any map.....
more or less follow always moddare from the 1500-1800 rpm and 50% load then...
search lamappa conversion nm to iq and moddala as recommended....
then you should also look for the map or lambda limiters fumes on the basis of maf and map...
as already said adapting the limitation to your request from driver-wish...
if in Dw you gave 20% more means that from 580nm for the past six to 696nm...
the same pair you have to give it to the lim torque, but you have to start gradually....
and only after the 2800-3000 rpm you can give the maximum increase in line with the DW....

guys keep in mind this file, I apologize for the chaos

I seem to have understood something.. thank you.
my only doubt ? on the axis "Z" that I don't understand where it is located.
you say: from the 1500-1800 rpm and 50% load then"
with in then you want to say, up to 100% right?

then I try to make a map where do I change only the parameters that you've told me before,
meanwhile, the increment DW as a percentage ? correct? or ? better to do it in spots?

the Z-axis, the other not ? that the contents of the map...if, for example, to display the map in a grid see very well that the outside of the table itself, you will find two columns,one horizontal and one vertical, which are highlighted in gray..those are the x and y axis...while the contents of the table and the Z-axis...these are the names for? you use them if you view the map in 2d.....
you for the "then" I am referring to from 50% to 100%...
for dw the incremto in percentage you can? do safely...
the important is to adapt the lim of torque at the request of the Dw....
and then adjust the other limiters...I am referring especially to the map conversion nm to iq..
and you have lim fumes or maps lambda on the basis of maf(mass air flow sensor) and map(turbo pressure)...

perfect all clear, proceed a couple of things for a time, otherwise I do mess
then along the Z axis are all the parameters in the boxes of the X and Y axes
called respectively the rpm/load
and then where are all the parameters

exact.....for? I repeat these names are mostly intended for the visulizazzione 2d and 3d....