Printable View
I purchased the following cable, the seller has confirmed to me that it was eligible for the lancia lybra.
It has provided me with the soft CARVAG but I noticed that it only works for other brands, I downloaded the multiecescan, but the interface is not detected.
I have to reset the light of the airbag.
Someone can? help me?
I do not know the cable in the object, but following the logic of the cable VAG kkl ? for cars of the VAG group, the name says it
you will never be able to make a lancia lybra with the sw carvag
if he works with other sw I don't know
This ? the cable I purchased
http://www.ebay.it/itm/320986191129?...#ht_500wt_1199
then you explained it all magi1984 and the same canvas I have written in your presentation, but at this point I think that you can try with the sw fiat ecuscan and this cable maybe it works.
it usually works...maybe you have a problem with the drivers..make sure to check the doors..uses xp??
Unfortunately, use Seven, but I confirm that the cable is indicated, and the software multiescanu works? if you how to configure it?
http://www.professionalchiptuning.ne...-vista-7-32-64
these drivers are going well for you both x elm and kkl. then you need to set the interface, do so:
intalla, the drivers put it in usb interface, go to control panel device manager ? see in which port ? put close, open ***********,settings in the pull-down interface put kkl, in the drop-down list below sets the port that you have previously localized to this point should go, another thing I think that x can do airbag you need the adapter, in each case, there are all the information in the portal of the creator of ecuscan.
Thanks prover? this week-end and I want to know
I tried Saturday morning without any news?, having to leave on Sunday, I was forced to go and/or a workshop to repair the error.
Prior to? I soldered the wires under the seat by removing the plug.
However, I do not give up in the search.