Printable View
hi I have in the workshop this peugeot 307 2.0 hdi engine rhy I made a scodifica total,the machine part is not in recovery but I still always have the malfunction indicator light turned on.
I wanted to ask you if is possible to work around this problem by making a scodifica that make me turn the light off.
from the outset I have tried to delete the dtc but always remain active.
I enclose the files that I made
should obscure it to the light immo ... so you never have a problem
The problem is that the radio display tells me fault anti pollution
Hello. how have you solved it? I have a peugeot 306 2.0 hdi engine RHY. EDC15C2, I tried with ecuvonix, immokiller, aetool, and nothing to do. I like tool, I have the kess.Quote:
Originally Written by scarface
Excuse my ignorance.. but the Kess law writes to the E2Prom????Quote:
Originally Written by nolaru
managgia...I was afraid of your response. No, kess does not read the eeprom. I was hoping for some solution from the obd without going to open the ecu, desolder, program, etc.
Then recapitolando: my edc15c2 peugeot 306 2.0 hdi 90hp RHY) has only one plug, in the picture, ecuvonix tells me to read and reprogram the FLASH 29F400. Right?
Aaabbbeee if ecuvonix tells you to work on the flasks, and proceed as you are told..Quote:
Originally Written by nolaru
I am still searching in my various software EDC15C2 working on 95P08 whether in full or in partial then I wouldn't know I don't remember having ever made of these EDC15C2 PSA only some EDC16
Cabbage. I don't have a programmer for is 29F400. I have upa-usb but do not make them. that pale
See that the 29F400 and Flash and you the law and / or serial "OBD2" or in Boot Mode on the bench..Quote:
Originally Written by nolaru
The eprom and a 95P08..