Printable View
Good evening to all,
I've read through the cock 2 via the eobd and processed the file with a time to rule out the egr and defappare, but I have two doubts...
1.Just read via the OBD, or is it necessary to read it in BDM to have the full map and defappare?
2. Time is suitable to do this ecu?
You might take a look?
Thanks
reading the obd is not good lack of parts the software goes to change I don't know if time is working well ever proven solution
I confirm what said by friend, the legendary..... must always be carried out in bdm this ecu, because of the pieces are in areas that you don't read from serial port.... for the accuracy, areas of the dtc, areas of the egr, and if I'm not mistaken zone clogging dpf....
Ok, thanks for the advice. Another question: is it essential to regenerate or replace the fap before I read the file in BDM?
No No and important to regenerate and important reset rate ash calculated as emulation is always clean
Well, I read in BDM after you have replaced the particulate and reset all the parameters.
For this type of ecu you are unable to exclude the FAP with the off switch, or should I rely on a software type time /ecusafe?
I would like to avoid deleting the area of DTC.
Any advice?
the time on this ecu nn works well in most it should also touch on useless things
In fact, I've seen that you edit several curves... But you can with the switch off?Quote:
Originally Written by tecnoecu