clone the ecu FIAT PUNTO EVO 1.3 75HP MARELLI MJD8F3.GG

Good morning to all
I would like to make a clone of this unit
Marelli MJD8F.GG
HW1FL 2841-GG44
55255946

in order to avoid making unnecessary purchases could someone kindly explain to me what the acronyms I have to take into account to be sure that it is compatible?
Thanks to all

hardware MJD8F.GG HW1FL
software 2841-GG44
number fiat 55255946

if you use the sw that you have already you need a controller with hw equal.

Thanks a lot
Friendly

Sorry
is that the ecu is only possible to read it in the BDM ?
however, it is written, even in the OBD'?
Thanks again

Quote:

---

Originally Written by gianni1001

Sorry
is that the ecu is only possible to read it in the BDM ?
however, it is written, even in the OBD'?
Thanks again

---

Not in the BDM, but in J-dag..

ah ok ,I've never done it in that mode
and it's particularly annoying to open and read, or it is in the standard?
if you have any tips are welcome ;)
Thanks

Quote:

---

Originally Written by gianni1001

ah ok ,I've never done it in that mode
and it's particularly annoying to open and read, or it is in the standard?
if you have any tips are welcome ;)
Thanks

---

Na rongia!! ;)
to open it, open it,
but to dismiss it as before I do not think it is possible...
reading and writing is always dependent on your tool..