Printable View
hello guys I wanted to ask for help to the pi? experts I have to install an add-on module seletron that has the cable that goes connected to the accelerator. how do I find the throttle cable, what?? I have to install on a punto 1.3 multijet 95cv fap 2013. thanks in advance to those who I can? help.
those modules "them" I believe that they go stuck on the pedal by removing the original harness and inserting the module, you must change only the travel of the pedal, nothing exceptional, then look inside the machine on the accelerator pedal, I in any case I do not recommend to mount the modules.
hello ugoboss the form that I have to install myself ? a module for the rail only has a wire that must be connected to the accelerator pedal. and I don't know on the accelerator which wire to attacarci this cable
there is not a single wire to the throttle, ec all wiring, and are two things, or who sells you the module gives you accurate directions, or throw everything and do not mount anything.
And also my contrariet? the use of these modules for the damages to the injectors and not only that they create.. then your ? also fap and then other problems,however, to answer your question you need to intercept the wire that comes from the wiring harness of the throttle, or if the pi? comfortable when he enters the control unit that has a voltage that varies from 0.8 volt to a minimum of about 5 volts at full load testing but find the one that varies continuously from the minimum to the maximum, why? there are also other wires that come out of similar tensions, but only to half load or half a full load,if you have not changed the placement on the pedal from the previous versions I seem to remember that it was the pin n?6 on the wiring.