ELM327 - Problems with Multiecuscan

Here I am.. even I with my ELM327 purchased as V1.3a .
I am trying to connect to my Alfa Mito 1.4 16V Turbo 114 KW.
The execution of the test interface is to a good end and Multiecuscan recognizes him as a V1.3+ telling me that I should not have problems with can interfaces, but when I try to connect to the instrument cluster to reset the dell service gives me the following error:

CONNECTION FAILED
ELM327->ECU Connection failed!
Check the settings of the interface, COM port, pin EOBD adequate.

Of course, I proceeded to change with the switch to be able to include the adapter with the yellow (or type 3) with pin 6 and 14 are shifted to 1 and 9.

If I do a network scan CAN find only 3 modules: BOSCH Motronics ME7.9.10, BOSCH ABS 8 ESP and Delphi electric steering.

With AlfaOBD I can connect correctly to the BOSCH ME7.9.10 CF5/EOBD (CAN) (parameters selected COM3, ELM327 USB/BT, Baud rate 38400).

I look forward to the enlightenment, in the meantime, here are a few photos: