tomorrow I should read a lancia phedra with edc 15 with kess clone and magpro2, do you know if there are problems in lettur ao write on this machine or can I go quiet , the usual tricks?
Printable View
tomorrow I should read a lancia phedra with edc 15 with kess clone and magpro2, do you know if there are problems in lettur ao write on this machine or can I go quiet , the usual tricks?
Mag pro ? the best tool for edc15, but if you set the option to speed? pi? slow you should have no problems!
both in writing and in reading?
if you block these I know that you do not in bdm, you must unsolder?
you must unsolder the 29f400 but ? very difficult for the blocks you can go quiet, even with the cock 1260Quote:
Originally Written by michele30
as you have suggested, with a magpro, go mode? slow.
we always talk about writing to go at a moment's notice? slow, why? in writing, I leave what I set the program to
also on the edc 15 we want to 40/45 minutes?
no,edc15 a couple of minutes.Quote:
Originally Written by michele30
here make sure that it is mode? slowly, I stuck edc15c7, then resumed with mpps writing the whole file...Quote:
Originally Written by michele30
if you're using an measures in reading, you have to do as well in writing, you can't do a thing one way and the other and so incasinate things and then locked the ecu.
I tried some time ago to read it in the OBD, but I could not, because the picture will be turned off automatically before the tool to finish to read the map! :(Quote:
Originally Written by michele30