Printable View
Hi guys, since it would be the first siemens that I'm going to read and write, I would like to know if there are any particular directions in the read a ford fiesta 1.4 last type that is supposed to mount or sid802 or 804. the cock 2 should make it without problems. I was wondering if in the case of the block ? simply find the file ori and rewrite it desolder the eeprom and if, perhaps, there may be other problems encoding type injectors etc in the riprogrammarla.
Thanks to all :)
made with a cock that mag messun problem even if in the case of a lock can be reset from the 29f opportunamende by decoding the file
but the 29f ? to unsolder or ? in the socket?
you can reset in boot mode these?
I don't know if they share in the boot but the flach not ? zoccolata should be properly welded but don't worry you are not stuck once the mag at the end of the writing gave me an error but the car parts is the same without problems
and,the valley desolder those,if you don't have a soldering station air or infrared I don't think that you do
no, with a station hot air heating well go as smooth as oil
Thanks :)
go quiet ,it's already made with fgtech that mag.. the ford with sid 802-804 succeeds to read and write to the serial port,while the peugeot/citroen with the same ecu.. the only write ..or the laws by putting them in the boot (but very risky)
but as it is, ford do not have problems,and the sid does not have the problem that you lose the encoding injectors.