lybra 1.9 jtd edc15c5 5 plug

hi all, I have a little problem and I need your help if you can, ok....I lost the only key to my lybra 1.9 jtd with ecu (edc15c5 5 plug eeprom 24c04, from there it all started:
1-trying to do the scodifica I was wrong by putting a file that is not focused anything, working on the flash 29f400, using galletto 1260, result blocked, I intervened sbagliatamene on the circuit and I burned
2-after I knew the procedure well and I bought another control unit, the galletto fgtech v54, and the programmer upa for access to the eeprom, the result.....the data sw and hw of the flash-unit were not the same as the original
3-I bought another ecu but it is a time, checking that everything was the same as the original one, and I finally managed to access the eeprom 24c04 by the partial, I purchased the ignition key and immo result, the machine has started, only that it does not work the fan and the lights for engine failure, airbag, and passenger airbag are always access, situations that had happened 1ma, and thus, I was wondering if you are missing with the new data of the flash 29f400 of the 3rd unit, I still have in possession the data of the flash 29f400 of the 1st ecu is burned, and then not work for me the remote, I would like to know how to set it because it worked again, thanks in advance and good day