Printable View
Hi to all, as the title if defappo a edc16 with ecusafe I've heard that it eliminates all of the dct, some say only those related to the differential pressure and others say that it only does what you need...
At this point the question arises...
Who is the expert who manages to make clarity in my brain???
Thanks as always...
sie so but you can re-enable manually!!
Might be these?
Ps once defappato I have done a test...
I have eradicated the debimentro and diagnosis gave me error... so I assumed that the dtc there are...
Disable the dtc relating to the dpf, sensors, temp, and if this lambda probes.
Also the pressure sensor??? if I do get a diagnosis, the values of temp, press, and the lambda should be zero? In fact, I never looked...
Thanks for the reply... it is so, but which of the three I mentioned???Quote:
Originally Written by carlo abarth
usually tap dtc relating to the dpf ,but often goes beyond, the problems arise when defects in the future you have the machine in recovery but you're no errors in diagnosis,
so if you have not sensor failure, you should re-enable the dtc,at least try if dtc on the thing can go, or leave so but remember in the future in case of recovery without errors, activate the dtc for making a correct diagnosis.
On edc16 if euro 4 operates the switch off without the use of the sw and the dtc will remain active
Usually ecusafe in the control unit of the ford edc 16 va erase all DTC.....
in the edc 16 a freelander 2 series I had also cleared the errors on the pressure of the rail
ecusafe delete other dtc in addition to those of the fap..
if the machine goes into recovery does not turn on the indicator and diagnosis of any error.
riattivali manually as mentioned and you're with the dtc on the kiaro support!!!