Printable View
Hi guys I have a question:
Can I use the same map that is modified on two machines?
Or better, I have two BOSCH MED 17.3.1 and only one map is changed,
The ID OF the TWO ECUS ARE THESE::
Hw: 0261s05618
Sw:1037509747
Spare:51881676
Hw:0261s05618
Sw:1037512340
Spare:51892030
From the outset I have already put the map on the second ID, AND there WAS NO PROBLEM, thanks to all
From the guys I truly need
Hello, try to re-read what you wrote, what you understand? then you say that already? you have rewritten and not c? was no problem, but what kind of response are you looking for?
Hello passion motors; and the true is not clear granch?,
Then I want to know if I can use the same file for two MED 17
hello I always try to put the file with the same hw and sw but ? also true that the sw may change based on updates of the homes of the mothers.
Maybe first read the two files ori and check them out by doing an overlay and see if the mods are all over the file, or there are small things here ? the maybe a few bits changed.
if they are the same hw and sw do not even need to use the application......it should be seen that your ecu are different you have already? my risposta.......No.......Quote:
Originally Written by Cinquinogt
If you have not had any problems perhaps ? why? you are only small variations from one sw to another, in any case, compare this to yet, best not to go to trial!!
You can do by yourself changes in the ori file like the one in the modified or open two files im winols and compare differences.
you can copy the increments from one map to the other,always, that the maps are similar
I ? happened to pi? a time to find the sw of pi? some ecu. and the car went into the bike safely! for example, the 500 abarth with the file of the GPA
Fill only increases
you'd better check the structures of the file in order to copy only the values mod on the orig file dell ecu
Quote:
Originally Written by Cinquinogt
Hello, if you have the same number hw means that one can? be a sw update, do not take it as a safe, but you can change the file provided? to be complete, even to me ? gi? happened with a edc15p and with a edc16c8 to make a clone with different hardware, in the first case, unsoldered flash e2p and in the second srcitto with bdm e2p, micro and flash, in both cases it worked.
Not for this, I say to you go quiet, if you can compare the two sw and fill the increases, my experiments were to make a clone with units of recovery.