Printable View
Good evening, of course, ask a new question for? in this round I can't get out of it...
Scodificare IAW 5AF of a point , open the ecu and found the ground pin, but I don't know if I put in the correct way to do pin-out with the gallov54...
with the special tool I can not start even reading (clone\decode).
I'm sorry , I was wrong in the title are cooked , I wanted to write 59F
you d? some error? the type system is not boot?
by an error, and me doing the log , but does not tell me anything else... I do not want to mistake the connection pinout for the 59f... you ... an image here on the forum?
hello to my esperinsa staff the cock 54 is not able to do these ecu I riuscio to read but could not write
I dunno , riprover? I do not want to mistake I, with the connection pin-out, but I followed one of your pdf!!
I v50 and the pdf are correct, I will say that with the v50, I've ruined 3-4 59f in writing.
instead with the old cable 1250 read from and written to without problems, we are talking, of course, hw above 100 boot mode
perfect... and then you say that ? the v54 which is not to be....
domandona I have a mpps12 and a kessV2 ... scodificare the 59f can help me?
don't you s? to say the v54 but my v50 f? of these jokes.
with regard to other programmers,possibly if your 5af ? with hw in excess of 100 something you can do(I think but am not sure)read the file of the processes with the sw for scodifica.
perfect , so I have to mount it somewhere and do it all over serial...
L MPPS ? a programmer that reads/writes only mode? the serial, therefore, not suitable for the scodifiche.