Hello to all
I open a discussion from which x error I deleted.
I had asked if someone could explain to me how to do the cut file ORI x a DELPHI DCM 3.4 sw8201145259 hw8200911560 a kangoo 1.5 dci 2011
thanks to all :-)
Printable View
Hello to all
I open a discussion from which x error I deleted.
I had asked if someone could explain to me how to do the cut file ORI x a DELPHI DCM 3.4 sw8201145259 hw8200911560 a kangoo 1.5 dci 2011
thanks to all :-)
discussion moved to the suitable section, do ir? attention the next timeQuote:
Originally Written by gianni1001
I apologize
Star? careful
Thanks
quant ? the size of the file?
email the file
Thanks Dell warning
Tomorrow morning the place
L I bed with a Cock V54
I figured if I can help you do it willingly
good morning to all
in fact, the map is only 128 kb
I read with cock v54 (at this point, I doubt that is able to read,,,)
I have attached the file
thanks
have you tried to see it in 2d the file? for meta map ? empty... try to read it with something else and see if ? complete
I tried to read it with Kess V2 but it is a slave....
the length is the same
among other things, I wanted to read a Megane with the ecu Siemens EMS 3110\3150 CAN ( to verify lid unit I read with Kess before), but the reading stops
to 66% and then it stops and tells me to turn the ignition off for 5 minutes, then continue, but then' error...
it will be the fault of the Cock to the point I am?
I can't xch? I can't find feedback on ECM tit I do Not find the driver
I have the gf version
't find the driver on this site don't ... you should see if you find someone that you the driver for ecm tit