Maps Golf 5 1.9 Tdi 105 Cv

Hi to all, starting from this address: 0ED0A4 there are 6 maps, the same of which I do not understand the meaning, someone kindly pu? tell me what match?

Hello, no I can? to give some clarification on this? Let me know, greetings.

I think maps are the values of the PID controllers for the management of pressure turbo,
none to touch for the original turbines

Thanks a lot franco, ok then, these do not touch, since you have been so? dear can you tell me instead, what corresponds to: 0E05CA?

I can't see anything at that address ? all to 0

As you can see all 0? That address ? the beginning of a map, serrated edge, is located immediately after the injection maps zoned.

ops sorry I have the wrong files, it would seem the map conversion NM to IQ. Sets the amount? of diesel fuel to provide a specific torque at a certain rpm

Thanks Franco, I imagined that it was that but I wanted to be sure, for this type of engine a 5% in the area of torque should be enough, what do you say? Or can I push myself?

Depends on what else you do.
You may or may not touch it if you do not want to exceed 330 NM of torque and 60 mm3 of fuel.

there happened ever now ke pull out of this car on the map and after 3 months the withdrawn out and compare the maps...
today, and I happened qst I compared and there were 2 parts that were different, but how can I do that?

Thanks again frank for your help.
Strange thing angelus, not me ? never happened.

I believe it is a problem of the program that uses to map....sometimes I will open the file of my car and just by opening the ori tells me that there are parts changed and asks me to save.....yet in the file by scrolling in 2d is not c'? nothing....I try always to turn off and restart the pc to be quiet, what do I do....