the reading control unit renault megane 3 1.5dci

Printable View

scican25

the reading control unit renault megane 3 1.5dci

hi to all this ? my first discussion here in the forum ! should I map a renaul megane 3 1.5 dci year 2010 !
the car in question is mounted on a control unit delphi I can perform reading and writing in the bdm ?
msport (exil77grande)

it was useful also to know the hp of the car, but as usual you are always vague,if it is the 110cv mounts a sid 305 while if it is the 90hp is mounted on a delphi 3.5.
scican25

Attachments: 3

I'm so sorry the car ? a 90 hp with ecu delphi

the part where you have to enter the e xxx ? in the upper left corner where there are those 14 holes ?
I post also a picture of the e xxx

in addition, I enclose a picture to know where to connect the power and ground

ecu delphy dcm3.4
cinqueturbo

Quote:

Originally Written by scican25

ecu delphy dcm3.4

S? and Delphy DCM3.4 me "seems" we can not do in BDM.. but it is in JTAG Renesas..
scican25

so what should I do ? how should I do to read it and then write it ?
cinqueturbo

Quote:

Originally Written by scican25

so what should I do ? how should I do to read it and then write it ?

So you can not make it s? the only BDM..
With Gallo v2 or v3, the read and write protocol JTAG Renesas,
or other HW that perform read and write JTAG Renesas..
scican25

I have the cock that is also the bdm and in the package c'? written fgtech v50 ! then I can do it or not ??
ugoboss

Quote:

Originally Written by scican25

I have the cock that is also the bdm and in the package c'? written fgtech v50 ! then I can do it or not ??

the version of the v50 has no jtag
cinqueturbo

Quote:

Originally Written by cinqueturbo

So you can not make it s? the only BDM..
With Gallo v2 or v3, the read and write protocol JTAG Renesas,
or other HW that perform read and write JTAG Renesas..

Quote:

Originally Written by scican25

I have the cock that is also the bdm and in the package c'? written fgtech v50 ! then I can do it or not ??

you have to see... select BDM-Jtag and see's? to the protocol...
scican25

but I am in the protocol bdm/jtag mode I as a driver mpc55x/56x so I can't do it ??
ugoboss

what is the protocol bdm, you don't have the jtag protocol ec' from version 53.
scican25

ok, thanks a lot, and for the sd 803 you must always make jtag, I have the I can do ?
cinqueturbo

Quote:

Originally Written by ugoboss

the version of the v50 has no jtag

Quote:

Originally Written by scican25

but I am in the protocol bdm/jtag mode I as a driver mpc55x/56x so I can't do it ??

ugoboss ta answered before me..