Printable View
are struggling with the reading of this eprom but I don't understand why? not me the law.
I unsoldered the eprom, which is connected to the caliper and adapter microwire.
I open the program, select the st95320, I click on the read.
nothing gives me error:
reading : 1 errors found device: ST95320 range : 0 - FFF
not ? that you put it in reverse to check the connections, clean the memory roll of the pond
to the contrary, no why? I have tried in both the ways, always the same error:
Dissaldala and put it on the e xxx welded or adapter spring if the woi read directly on the pcb pu? give problems
I,with adapter spring you have to read it,wipe clean with trialina with the caliper and not recommended!!!
adapter spring ? this?
I enclose a photo.
connected so not the law, do I have to connect another?
yep, I fixed it, but I didn't think it was so challenging, they could even make it a half-a guide to the use of adapters.
however, I took this cable Clip Test SOIC 8pin (POMONA 5250) - Cable, for nothing if you do not read the micro so.
then from the ecu or framework that is not the law's true with this caliper?
thanks raga
on the pcb, some other times it's no better to always unsolderQuote:
Originally Written by michele30
guys too I have this problem I need to read eeprom 95320 with the upa, but I read that I need this spring-there are other solutions ??
sorry but in upa there is not the pcb that you could solder and go on with the reading??
we want to adapt with the upa was to save time and make direttaemnte
Try to heat it with hot air, and proof reading quickly.
I dissaldo always because the direct reading I don't like I had problems in the past and I just.
However, one must always thoroughly clean its e2p that adapter spring-sometimes the contact is not good, and the upa won't tell.
In fact, I when I have this kind of problem, review the pins of the eprom with the new pond.