information class b 200 year 2011

good morning
I just bought a class b 200 of 2007 and through my workshop I provedutto to do the remapping to modino.
my father has a class b as mine, but the year 2011 (w245) I have noticed by the control id,is mounted with the edc 17c43 (processor tc1797)
as are, say, a novice in the world of mappings (my made my co-worker )? possible to do it with galletto v2?I ordered and
I should get to days.
informing me on the vs site, I have also noticed that being a tricore must be disassembled and prepared for the boot right? for the connection issues I have no problem with balance on the processor of the video games for a living ,and my problem ? know if the galletto v2 behaves properly on certain types of processors.
thanks for reading guys !

daniel

got the material (gallettov2 and ecm) smadonnato for the configuration and the flash of the hardware, but at least it works.. my b the law in 2min and 30 short-we'll let you know what comes on the edc 17 of my father.
greetings !!!

I hope in the boot.... save all before

sisi mine was a very simple edc16+ done safely with obd.
that of my father ? a edc 17, do I need to necessarily do it in the boot.
as soon as I dump I'll post it so you tell me if ? ok.

do not have too much of a hurry for the bootloader you have to open the ecu do it before some other reading edc16 bdm and see if everything works.....

certainly sno thanks for the advice! I hope to be helpful to you in some way on the mechanics and electronics of the mercedes benz �

Quote:

---

Originally Written by danielinoMB

certainly sno thanks for the advice! I hope to be helpful to you in some way on the mechanics and electronics of the mercedes benz 

---

The edc 17 after 2009 are in the boot. If of good quality, the cock should not have any problem in the work.

will update via obd of course the rooster is good at the moment.... I almost started the edc17 :D

Quote:

---

Originally Written by danielinoMB

will update via obd of course the rooster is good at the moment.... I almost started the edc17 :D

---

calm the council read in boot mode, so the breakouts and once you have read the entire experiment in the world then I know pain if you grippa serial

of course, I do not write if I don't have a full dump.?
but there is a guide on the procedure (for example, remove restore power) step-by-step.for the links no-problem are 5 threads, but to avoid damage if there is a guide that would be great

the first line written by me, it was an exclamation point does not mark errorino...

Look in the installation folder of the rooster, there should be a pdf with the whole procedure, and the connection diagrams.

already checked out thanks! I can only find the links by the cock to the control unit

the first of the links you should also find the mode? to use the software, if we speak of the same pdf.

I believe they are the usual pdf :D

guys read!!!I tovo 3 fie now
xxxall
int.flash
and eprom.
must be decrypted? which one do I use?

will update that ? the ver. master my

if you have a master do not need to decrypt own nothing,the file to use and the int.flash

thanks guys! I have edited the map with race 2000 because the ecm was not the driver unfortunately. I'm writing the flash! crossing my fingers!!!

everything is perfect!!!! goes great! thanks for the advice