The last update for the Abarth GP 155hp first series.......?

Hello all,
I wanted to ask you a question,
I have a abarth first series 155hp mapped that every now and then turn on the malfunction indicator light and the error of d? ? a code without a name which in TEXA say corresponds to a mixing incorrect....... now the experts tell me that ? a common problem for those mapped and that for some time there is an update that make the fiat fix this problem.......

Now, someone's? pi??????

? for case, only a GOLDS that shows the car in the original, and therefore, would solve the problem by overwriting the MOD, or actually there is a new GOLD (not s? to say, I suppose...) linearization of sensors, and then the limits of reading parameters pi? high on which to report changes, eliminating the problem of the initial real?????

if someone has it, could you post it?

Thanks

the council ? to review the change to electronic hoping competence and knowledge, if with the original e-the problem does not comes out with the error ? in the edit electronic...I've never heard of tjet original with problems of carburetion/spy nor updates for similar problems.

Hello,
the only thing that s? pi? and that they replaced the pressure sensor and it seems to me that of gasoline with those of the SS (same version, first series), but not s? if ? was made a linerizzazione......it needed to be.

if you know how to test for them or where to find the addresses of the management of these, you can write it?

Thanks

when replacing a sensor as any ? necessary to adapt the data of the new sensor on the map of course, but even if it had been changed by the pressure sensor l the induced error would certainly not have fuel from excess pressure, or pressure adjustment

no the pressure sensor, but as I said I have changed the pressure sensor, gasoline...... maybe should be linearized....... this is the doubt that I ? come! you have the address to check these two sensors??????? of how many points you should edit them????

fuel pressure sensor?

pressure fuel regulator just in case...that's not it never changed unless there is a fault, should never be installed adjustable asymmetric

here is s? that this should have it replaced with that of the SS.....

you only have to do a test, install the original file and if the error does not occur you know for sure that the problem ? was created with the change to the electronics, the sensor of the ss ? identical to that of the lower versions, the rule always in a linear manner, the fuel pressure in function of the manifold pressure.

Hello I advise you to replace the file ori and then have a nice reset of errorie reset parameters autoadattativi you walk on the pi? of a few days. In this way you should be able to put all the values in place. If you are from the pi? problems means that the mod file has some bag.
NB this kind of car must be rescheduled with the aid of a tool device in order to have the relationship lambda optimal.
Know if your coach has done the mapping with this tool

not ? need to check the stechio with extra tools, what you see from the diagnostic socket ? pi? that's good enough for a perfect adjustment...and I would add that if you have the knowledge ? just set up the exact strategy that the engine will be running? so perfect as you ? set l electronics.

If you have a good knowledge...

E-mail the file... sure that the error st? them...