Printable View
hello all,I purchased a progammatore willem pcb 4.5 but I can not get it to work for me it always comes out the inscription :hardware error check power and connection
the progammatore and connected with the door parallella and powered with 12v power supply for? I have always the same error.
The pins are placed as in the figure said to him, and I have a plcc 32 is inserted.
I don't know if you will need a different setting or something escapes me,I hope that with your help I can fix.
check the ports in the bios must be set to ecp+epp if I remember correctly, something like
Also check the dip switch are set to the correct way to get the voltage just right...
hello I connected to the usb port and I have read a couple of 27c512 and okay,hello
ben willem kullandım. loves zor eprom programlayıcı.
I invite you to write in English thanks.Quote:
Originally Written by chare
I ? just recently joined the Willem 50e but I have a big problem:
Before programming a 27c010 socket PLCC32, I did a little test, I tried with success to read and write the 24c02. sop8
Instead, the countless attempts of programming a 25VF080B (a bios of a moterboard), in and out, cleaning the contacts, with clips defective, (maybe even a change of voltage 3.3 v/5v) not have been successful.
By other evidence, after having read it, I fail the check by returning an error x000000 etc...
I soldered the leads and I placed them directly in the socket of the programmer.
I now have averted any false contact, in fact, I always detect the device, instead of the first often he did not.
However, the result does not ? changed. Returns similar errors in the programming phase.
It is possible that the false contacts have burned the component that is clear but not reprogram???
I do this question why? before trying to desolder, read and reprogram a 27c010, I would like to test the reliability? of Willem.
Thanks
the 27Cxxx PLCC are not reprogrammable, eprom, OTP (one time programmable) once you've programmed it so? remain...while the 27Cxxx DIL are programmable if you have the window to be erased with UV.
if you try to cancel or reschedule the 27Cxxx PLCC harm.
for the discourse of the reading and writing of the eeprom for the bios, is always that the programmer can do, often have a particular routing such that ? need to have the adapter plcc to dil senn? do you not read and not write, and not all adapters are compatible with the programmer.
the version that you have is not a good programmer ..I think it is a matter of setting!!!
capers! not the know all these things...
not that bad I tried only... cos? I have avoided damage.
The thing that me ? seemed strange, for?, ? the Willem that I bought on the card has already? the socket "square" for the 27c010 and as I understand an ecu that I should scodificare has the code right there.
Should I desolder and read the 27c010, process the file, and rewrite them to the content on a new????
exactly!!!and be careful to do the right file!!
if ? an ecu VAG is not needed to do the job on the PLCC but on e2p.
It is a siemens of an old Skoda petrol; also I thought that the scodifica you did on the E2p, however, that here on the forum have told me that it was on the 27C010.Quote:
Originally Written by carmageddon
However, for now I gave up; I could not to venture into this business too risky... it Was a favor for a friend had to do to a friend of his...
I saw a "Willem" made in china someone knows something as they go? Costs 20 pi? or less than pi? ss