Printable View
Hello guys, give me an idea to solder the spring contacts on the e xxx bosch template bdm.
Today I tried to solder them ? a casino all crooked, remove, put,remove,put... I didnt
as you have done to be able to pay off all straight?:mad::mad::mad::mad:
I have them welded by taking as a reference a edc16... one by one I would position the straight and until I pay
I have welded many of my method, and put all the needles in holding them steady with the plastikina(DAS) then balance one at a time, taking into account the distance after welding, remove plastikina!!
I did just yesterday qst work, hell, straighten them scioglievo slightly in the tin, and them wanted to stop, I have come to the pi? easy the ones with the needle is small, that the two great.
at the falls on the right just a question, yesterday I noticed that some of the contacts are not connected and I thought I would not weld the spring contacts, in order to keep them in case you break someone, I have done well?or do I have to put them to?
you have to put as shown in the diagram
Today we tried again. tonight I thought I'd make me a template for the pin to spring.I want to take a piece of wood the size of the e xxx, but more?
deep. I'm thinking to put the wood under the e xxx, then in the drill press to make holes passing from the e xxx.I hope for the best.
Thanks to all
that means, as in the diagram? on the board, and I see that some pins are disconnectedQuote:
Originally Written by alex68
the schedule simens and marelli are a casino solder them straight on the ideal would be to have the ecu below to check while you're welding
then,I cos?,I take the schedule of the original bdm and the print on a piece of cardboard so? I still have the form
once you have taken the form, I put the e xxx weld on the mounting template and insert the pin to spring centering holes in the cardboard
once I entered all of them and I have them aligned well to the hard cardboard at the base of the jig and start to solder with the soldering iron smd in order to do the job clean
the bosch are very easy to do...
But.. You're building the schedule spring
The piglet? Watch that they do not cost a lot ;) you risparmieresti a bit of effort
no, give them a series with the template... however, I have them welded by blocking the bosch with the delphi and the other to the eye, but the idea of sportnight ? nice!!!Quote:
Originally Written by oakley1
You Sandro, but then we need? c'? of solder
Unfortunately I do not have shipped the original schedule. Now I see if I can recover them.
Do you have any address to buy them?
No I bought them with the template but there are individual and you have to solder them in platelets where fellowQuote:
Originally Written by oakley1
the flat of the bdm!
... I Understand... Is that there are already? ready!