how to map fiat sedici 1.9 mjet 2007

Hi guys


I have the rooster clone and mpps v5 clone available,with what I consiliate to do it? the sixteen me out but the new model with engine 1.6 mjet 16C39 K-line.

Thanks in advance for the answers.

hello,I think with the mpps v 5 you should not have problem x, and a common edc16+ ,I made the mag pro without problems,

Thanks polini.
But with which car I can work with ?l mpps in place of the sixteen?

from the list mpps and mag pro are all 2 edc16c39 wedi if he can id do the ecu, I think that will be the same protocols

Usa sixteen protocol 1.6
And only a graphics error,not esisste the 1.6 on the sixteen,only 1.9 and 2.0

I fidodidotuning uses the protocol 1.6 already? made pi? times with mpps12

I read and write with mpps v5 quietly, at the time of writing I had to put mode? recovery is not wrote

Thanks to all for the help, you are very kind.have recently joined this forum and already? the in the heart.Good Sunday to all.

no,I don't believe... and probrio fate that I have to map... now I will explain: Everything is ready to read, (booster, etc...) I try to open mpps but does nothing, ritento and I check the error "Application Already Running !!".Now that I think of it well, yesterday I turned off the PC after you have done the usual updates to win7.
There happened already some time???
thanks in advance to all

have you tried to uninstall and install the software sometimes goes to the brain I so I sometimes do and tt works

No, but I installed the program again.but nothing.now they are in the workshop, when I get home I try, re.thanks Polini

I would recommend that you always use xp for these tools ? the pi? reliable

also try to disable antivirus but and installed on xp as mentioned Joseph 1374

No use win7.I uninstalled the program but I can't find the download link.do you know where to download it?I have the driver to install the hardware with win 7.
Thanks for the help.

thanks to all and especially to the polini.

ok then there's nothing to do. Then I do not care much to map this machine, because of my father,but I would like to understand why this comes to about 30% after about 15min. and you block with an error message. The voltage, I is constant 12.9 V. Who me, can explain it,if that is possible.
thanks to all

the what ? strange, try to read it with the cock

test with another protocol edc16c39, odd, though, I mpps v5 the made

But not the risk of the block?because after the error I accetava the code of the key.but then you and put it to work only.type a suriscaldo of the eeprom.

in reading don't risk the block, as I said, the test with the rooster!

you can try as an alternative with the mag pro

Now I am outside of the country.when I get home I try.a good Sunday to all