doubt antituning audi a3 2.0 140cv year 2009

hello to all.
I was contacted by a guy who wants to map his audi a3 2.0 140cv of 2009.
I have not yet seen the car but me ? had a doubt.this model has the antituning?
also while reading it I could lock it?how do I know if it has the block?
thanks

not reading it blocks the safe, see what fits for one thing, many starting from 2009, the antituning

if it is of the period 6-2009 it is likely that it is antituning or otherwise, even if it is older you may not know if it was in the audi for updates, and then became automatically antituning,you can not really know if the' tene realize only after it is written that part the most,you can still read it if you want but it makes no sense.

? the end of 2009.then you do not risk.
Thanks.

risks,the leak in the boot? much more simple than it might seem...
or at least you make the back up and then try it in the obd

that mount? a edc17?

it should be edc17cp14

the way you should do? gallo 2 in boot mode?

Yeah,the open,see ke processor mounts and therefore see the right pin boot-to-use...

edc17cp14 the end of 2009 ? protected, do not risk, do it in the boot as it says in Fidodido!

It is, in fact, I don't want to risk it.if he agrees to get him to open the ecu otherwise not risk.

You for? also in the boot if you don't have a antichip tuning the blocks so I don't know if the expenditure is made

Hello

we do not say nonsense,if you do it in the boot go quiet that you will not have problems,if not the law, and tells you proteta by a password,just remove from the boot,replace the green wires of the igniction with the 12 volt,selections tollprot, the tool derives the password and putting it in the boot and the read and write easily ;)

But when you do boot it locks, too! My ? just curiosity? to understand
Thanks

Hello
E-mail version of hardware and software, and tell you you can do in the obd.
Are various tricore protected (Tp2, Tp3, Tp8, Tp10) difero, some you can do to obd, and the other only in the boot.

When you talk about it in the boot you are referring to the bdm?

Quote:

---

Originally Written by gezame

Hello
E-mail version of hardware and software, and tell you you can do in the obd.
Are various tricore protected (Tp2, Tp3, Tp8, Tp10) difero, some you can do to obd, and the other only in the boot.

---

when I see the owner of the audi'll ask her if I can take the data hw and sw,I didn't trust even read it

the boot ? different from the bdm,the bdm will colleagues over the schedule directly on the motherboard of the ecu
with the bootmode you connect with the wires on the contacts of the bands of the control unit

Quote:

---

Originally Written by pabloescobar

When you talk about it in the boot you are referring to the bdm?

---

Hello
No, edc17 not to port bdm, jtag port.
I refiri to tricore-boot.

??????what?????

edc17 you there colleagues only on the comb and then wire boot on the circuit board,but if you use the kess he can? also use the doors bdm pi? the wire boot