galletto1260 law centrallina alfa159 120 hp 8v

hi all, I open this post because the galletto 1260 does not find the driver for the alfa 159 8v but only for 16v know if I can read and write with the driver of the 16v thanks?

The protocol and the same.. which reads and writes

thanks alfajtd for ls response, but are you sure you lai already tested you with some other car 8v. not read all the fine and then write me down lecu?

if the blocks ? a problem of the clone...

if you do not trust change instrumentation...

too easy lai read and written an alfa 159 8v with cock 1260?

I don't use the instrumentation....

other well before you are....

so I repeat if you ask and you are given the answer you only have to try... the protocol ? that.

if then you do not trust what you bought, I can't do anything about it....

thank you for your answer but I'm looking for someone who's tested already the cock 1260 on this ecu. as for me, my equipment goes beyond the gallo1260?

the 1260 clone reads and writes to the 120 hp, personally tested.

ok thanks do you know how to call the driver please?

use one of the 159 150 hp, the ECU ? the same

ok thanks now I try.

You go quiet if you change the file to verify the correction cks.... The protocol 8-and 16-v are the same

anyway thanks to all for your interest and your help, I tried with another galletto 1260 gnente not the law is only ecu data?

Try to read by putting speed? minimum

are the drivers that break,there are crazy well I went 2 times, and 2 are no,then if you have a elm usb rimbambiscono both of them...then I decided to take a mpps and ? I ? passed insanity

that error message it gives you when you try to read ?
It is very strange why? I've done a lot of reads/writes on the 1.9 120cv and I never had a problem.

I also I have read some of it and no problem

Also I've done a lot, ? a driver issue, safe

which operating system you have, ? strange that you cannot read, usually the galletto clone if of good quality

was missing a piece, I said, usually if good law, even the stones, the problems are and then write

for? if it is the ECU id, the drivers are installed and they recognize the interface. It seems strange to me that doesn't read, I would not like the car ? wired type 2.0. It would be strange this is to? you never know. That goes wrong you can try to tour

If you have driver problems has problems in reading, but the data from the ecu makes them, that's.or. you?

you girls ecu data makes them?

I confirm! the bed is 120 hp that 150hp!

put a battery in parallel to yours, and try again.

I honestly addition to the battery in parallel would use a mpps so x be sure.

try to clean up well from all the drivers and then reinstallali

the read-id the ago although ? installed bad,the problem ? it keeps the communication and then does not finish the read