Printable View
So guys,I had a ecu to throw in the workshop,it was a g.section 1.3 mjtd
I used to try the bdm, but after reading that ? went even to a good end,he stopped dif unzionare,every time I exit mpc family error
as if the unit is not to be linked in practice
now I would like to know,you can do something for this ecu?
? a GPUNTO 1.3 mjet 75hp MJD6F3HW03P 2944P748
I would like to maybe try to force the writing to see if someone has read in bdm also if you think about the bdm, I did not recognize I do not do more? nothing
skedini spring or welding do you do to read?'
I had loaned a friend of schedule spring but I know that the next time I go to welding
a,by connecting it with the galletto 1260 to tour me reads the data from the ecu but I will return zeros and points....
the scripture gives me error
you say that the jot?I hope to find some other unit to do the experiments before using the bdm :D
if the ecu ? a g.the point I would not like to be wrong, but on the bench there do nothing, not even the id ,then with the galletto 1260!
the problem ? that should not be even in the bdm now,to tell the truth was not that great even before,then I wouldn't have it already? ruined and I'm eating the head
but I wanted to know if there was a way to check
so guys,today I tried again and surprise surprise it works!!!
recognition and reading done,I returned a single file that is opened with the ecm in practice does not represent anything,I explained a bit how should I act?
you read in the bdm ? maybe you read the entire ecu...tries to extract the flash and then try again to upload the file !
sisi,thanks
in the end I resolved
tell us now
The program of the bdm also allows you to divide a reading of the whole or merging of the readings shoot
in fact, to replace a new ecu if the code hw ? equal to or ameno only change the last 3 numbers on the bosch
just write only the eeprom