You can? write this car with mpps12?
In the list fiat, I only found the large point, which does not c'? the 1.6 -, or c'? a similar protocol?
Printable View
You can? write this car with mpps12?
In the list fiat, I only found the large point, which does not c'? the 1.6 -, or c'? a similar protocol?
mounts to a edc16c39 then try with the other protocols of the same family.Quote:
Originally Written by panterargento
I l' I is made with magpro2..... read the complete file.... and write only the tables ;)
Prover? with the alfa 159, but with the one that makes me the ecu id with the one then it will have to? write?Quote:
Originally Written by msport (exil77grande)
This, of course, v? cut to 1mb?
why cut it to mika and a marelli????Quote:
Originally Written by panterargento
Yes, in fact I am confused with the 75 and 90hp....:confused:Quote:
Originally Written by carlo abarth
Therefore, even the reading you can? do so without compromising the file?
The fact, ? that s not? the protocol to match...
as already said the test protocols of the same family, the first one that identifies and reads the uses then to write.
Ok, follow? your advice...right now I have data only of good.Quote:
Originally Written by msport (exil77grande)
I was not able to read the ecu...also choosing other protocols such as alfa romeo 159, croma, bravo, etc...:(
Someone knows something?
Hello to read this ecu K-line, you need to bring it from the engine control unit to the diagnostic socket, the network k.. as on the diagnostic socket( obd )? this only the can network.. the procedure to run ? this: connect the pin 25 connector To the wiring side of the engine control unit to pin 7 of the obd.. after that you can use any of the read protocol edc16 c39
Should be the same mechanics of the bravo, which I have read quietly with mpps5...
Not ? maybe there st? any help...? Maybe a step by step procedure...a few more might be useful.Quote:
Originally Written by Backgroop
I have already? tried with protocol good...but nothing.Quote:
Originally Written by blackwolf76
For the mode? reading via cable, k ? simple enough, you can disassemble the unit and make it to the tour, all you need is the pin numbering of the controller, which you can find on the banks ' data type ********.
but do not make it in the bdm and giacch? you equal your ass???
if you can? of interest I have a template with a schedule for the bdm, and a rooster v2 that they give me...Quote:
Originally Written by panterargento
For the moment, no, but terr? in consideration of the proposal.