Map Golf 4 tdi edc15p 101cv incredible

Hello all,
I got a person who asked me to check if his car had a remap, I checked and see that the map c'?ra on...140.000 km in this configuration and has little insight into the turbine (? open the nut with the impeller disintegrated).
At the time, the previous owner said that the map on the page? 400 euro by an operator of my parts that are sure to rimappe, you do not understand anything as it uses file is ready, but does not rely on any coach.
The car to a minimum, stops, shakes in a way that is absurd, as if it has no motor mounts.
I think that's because from the damage that has done to the map? I'm willing to bet that me putting the ori the vibration would disappear if it did not compromise the mechanical parts.

ahahaha quiet that even if the pressure of the turbo has some high points, I don't think he broke the turbine to the map that has neither head nor foot,have not touched anything and the one that touched on looking at the graph of the titanium and been done at the rpm and load is too low and increments absurd that sensa without the fact of the tremolia may also depend on the map and then the first council and will file ori and try a good machine.

Thank you both..***** o wants to replace the original for the moment to see if the flicker disappears, and if it makes less smoke. Rightly, I propose the map, then the decision is up to him.
Can I replace the ori downloaded here and that is enough or I need to calculate cksum?

you can safely write to the ori.

forgive the ori, they are right, our friends would walk head map increases differents species in the bass.

Put the ori immediately and toglio this havoc without**** queue. Then, if it's gone the defects that complains you can? think of a map soft visa (in km)

I've seen this file, I tried to do a mod on the original that I downloaded here from the forum...
I don't think I got it all for? I have banged quite a bit!

Quote:

---

Originally Written by dvdtuning

I've seen this file, I tried to do a mod on the original that I downloaded here from the forum...
I don't think I got it all for? I have banged quite a bit!

---

yet for a princiapiante although we speak of a edc15 that' one of the most easy-it's not too bad,egr off ok,limiter turbo out of the driver ok,only problem is a thing a bit monstrous on the map injection zoned 2 and then on the injection zoned you may work with a little more sweetness in a progressive manner.

Quote:

---

Originally Written by msport

yet for a princiapiante although we speak of a edc15 that' one of the most easy-it's not too bad,egr off ok,limiter turbo out of the driver ok,only problem is a thing a bit monstrous on the map injection zoned 2 and then on the injection zoned you may work with a little more sweetness in a progressive manner.

---

I imagined the problem of injection that I still don't understand the logic...if I guessed right, those are all the maps in advance right? I speak of injection zoned map1+map2+boostxrpm1 + boostxrpm2 and related...

I enclose a new step, I had not realized the error unwatchable...Improved?

Unfortunately I can not download the file to check it. However, on the edc15p just a few things and the car goes very well, my ibiza cupra mounts the same ecu but with soft and hard different but the logic ? the same.

It is the first time I touch a edc15p. I look forward to the comments of the professionals...

they've told you... not bad....

Quote:

---

Originally Written by dvdtuning

It is the first time I touch a edc15p. I look forward to the comments of the professionals...

---

careful that the map injection zoned map2 1/1 has still increases mostrusosi,for the rest you can try.

Quote:

---

Originally Written by msport

careful that the map injection zoned map2 1/1 has still increases mostrusosi,for the rest you can try.

---

Forgive me, but the other step correct I had saved. The increases monstrous were the same as the previous one.
I finally edited down a bit degrees.

hello, the car is shaking why? get too much fuel at idle and the flywheel, f? hard to turn, usually if a car is shaking so much at idle ? for that.... unfortunately the map is not the I can see, but in fact there will be? fuel pressure too high at minimum

definitely will have also touched by the rotary pump, raising the pressure of the fuel

Also, according to me, too much oil and a little air