as the title
clear tested 500 siemens VDO 51782985 5WK43808
Printable View
as the title
clear tested 500 siemens VDO 51782985 5WK43808
it should I do,I open it but I can't find the e2p you know how to recognize it
? smaller than those in the standard is close to the condenser in the anolo of the ecu if you take a picture you pointed to
I found it,but I do not know how to read it,counsel?
read it as a st 95320, or tell me what you read above.....
the problem ? that ? pi? small compared to the classical e2p,and I wanted to know which system to read it,if I have to unsolder
unsolder then there are adapters or solder, or the spring to put inside in the controller if the controller ? equal take a ep2 new and write it down clearly controls the frame for? maybe it was better that flipped open a post, otherwise the administrator then we scold if you need more there? problem......
After I ask him to change the post,but my problem is the video is not a e2p normal and smd
change the post and post photos cos? let's see.... I have gi? made three, I had no problems, also one of the new bravo ? similar....
there are adapters weld-on or spring-or do as I did with the first wire small copper you connect on the pins in the pidinature ? equal to the e2p pin 1 is on the dot
hello can you help me I with carprog I have problems ,I read with upa if I send you the file restores ,thanks.
Open a post indicating the hw and sw then let's see what you can? do....
put it that you retrieve quiet
here it is, thanks to the availabilityQuote:
Originally Written by explode82
here it is
thanks to the availability unfortunately, I can't still download from the forum if you do not ? a problem I can give you my and-**** ..................thanks again good job.
Quote:
Originally Written by alexracing
the regulation that you probably have not read it prohibits what you asked for you,otherwise the limitations set it would make no sense don't you think?
me and happened about 500 mtj with siemens vdo 51782985 I does crash but no go light on drivers of both the red and the yellow in the diagnosis before resetting gave sensor-front impact-shock rear right - side impact left after reset no fault xo spy on you, and never happened to you?
This happens when the sensors are not good, you can opt with a resistance, but ask the owner of the car if you want all the operating system or not, if not in the case of a further accident, the airbag is not bursts
by when should be the resistance? and then it should be placed under the seatsQuote:
Originally Written by explode82
I ? stumbled upon a great point, I've resolved with multiscan doing alignment proxi specific on airbag control unit
I tried already with proxi alignment but not va, errors in the ecu there are no lights are on. what do you advise me to replace the file that was?Quote:
Originally Written by alexracing
there someone who has the file ori of this ecu 51782985-5wk43908? can I write it with xprog with the setting of the serial eeprom-st - m95320?
hello check that all the sensors are good and have replaced the capsules explosive airbag
I had the same problem alignment with other diagnoses have not worked with multiscan you