Printable View
I'm doing readings-scriptures on edc17c49 and all the times I have to open it and close it,and for now I cut the seal, and I closed without putting anything,I wanted to ask if there is a solution that all the times I have to cut and risiliconare
I had the idea to bring the pin of the boot externally,would it be feasible?
I don't see the need to replace the ecu with silicone, if when you open it it does not bend or ruin too much of the lid you can close, so without silicon, remember that in each case, the control unit is not hermetically sealed, if you see the black cap which is on the ecu the same and open to make antrare air, so it is not watertight, as far as the wire boot external be honest I find it ugly and the price now there are also new tools that read and write to the ecu at the desk without opening them in bench mode.
Ok,for the tool you are referring to the original or the clones?
both, the original already there are several, but now also clones that work bench mode you are in.
a clone that the law in bench?
of course, I got it and it works fine.
But the kess2.47 the doing in the bench?
no the kess clone is not doing bench.
Which clone is?
I can not put here the addresses of sellers, "foreign" but if you go on ****** and type-bench mode, you will see that something comes out.
ok, yes the asterisks are in place of a well-known search engine that starts with go and ends with ogle.