Problem golf 6 gtd at full load

Hi guys,
I have a problem with my Golf Gtd 2.0 cr 170cv mapped without without DPF EGR,
to which I can not give an explanation.
the machine makes good, zero smoke, but in 5 and 6 around 3700 rpm, 4000 rpm 4200 rpm, what happens is that the car has a slight drop as if alzassi for a moment at the foot of a few mm,
it feels just the push lower and then resume.
the problem is very noticeable in 5 and 6.
I repeat, you feel a slight loss of thrust, but immediately after it continues to push.

with-file-ori no I noticed nothing.
I tried various files, even asking for the service here file on-line, but it is anyway.

to any of you ? already happened to a similar problem?

Thanks

sure something left out and/or not taken into account...
I have never had problems like that

Quote:

---

Originally Written by alfajtd

sure something left out and/or not taken into account...
I have never had problems like that

---

I also thought I, I then asked for a file, even here msport, but the problem was the same...
I would not like something on the machine, for? with the ori no problem...

without the mod file nesussuno you can? say what ? success.

have you tried to check if you have a drop in rail pressure?
If you have a drop ? likely that you have the diesel fuel filter clogged or there is a problem when kiln feed diesel

you sorry... here is the file...
I haven't checked the pressure, the air mass in the intake...

I don't want to know who has done these steps... since this will be the property? someone from the forum...
but I would say that we did not own....
I'm sorry but the error as I suspected st? l?...

Quote:

---

Originally Written by alfajtd

I don't want to know who has done these steps... since this will be the property? someone from the forum...
but I would say that we did not own....
I'm sorry but the error as I suspected st? l?...

---

the error is there, where? in the remapping or in the exclusion of the dpf and egr?

Would you be able to fix it, or at least tell me where to fix it? Since cn all files happens?

in order to respect the work of others you need to you put in place by the creator of the mapping...
if you've been rather leave the ori with the dpf and egr off.
meet tool VAG and try to understand....
are not simple ecu... in the sw ? complex..