Discussion: manual for beginners for ECM Titanium

Originally Written by Peppino

The ask? for the courses to the admin hoping that I did not ask for digits high you know you sti periods there is turn na lira macu to see her cu lu binoculu. Anyway, thanks for the response.Hello

[/QUOTE]

Hello,

I can advise you I also the courses of the admin! I'll say one that already? he learned that little to start only thanks to them! Before it was all an unknown quantity! In this month of courses, also in Rome, so if you are one of those parts, or you can go ask now! Remembered that the one that you will spend you will return? always behind!

and one thing that I do, and I thank you for the advice, for the less c'? someone that already? the fact to give a straight.
these days are very busy but just find space to proceed? immediately.
Into the country from me, there are mappers that boast their ability? but I have never heard a vehicle mapped by them.
Thanks hello

hello I have 2 questions about ECM

1: ? possible if you select any part in 2D, to me this should also be seen in the HEX code or Ansi? If a driver ? was chosen and ? located in a map, but also goes to a parking lot?

2: ? in fact I use ir? common first builders different versions of the software in the controller. Every so often, to?, they have about the same maps, but in different places.
It is in any way possible if two files with the other with respect to postpone the areas so that the overlaid the maps, so you can directly compare?

I hope you understand ****** Italian, why? I can not find any English

Maybe ? you better write in English that you understand better!

Originally Written by pitty

Maybe ? you better write in English that you understand better!

discussion cleaned, by regulation, writes in Italian

Sorry I didn't remember this thing here!

To answer! You can do this just select the two original maps and insert it as if it were modified.
After 2d, you can scroll through the maps like you always do and overlay to see the differences.

I know how to compare two files in the ECM, but in the case of two versions of the software diffrent the pi? sometimes the maps are on diffrent places ..

cos? when you chosse a driver and go to the map you see only nonsense in the other file, why? the map matching ? the place different.

So there must be the possibility? lay both of the maps that are common to each other.
Do you understand?

In this world you have to spend money if you want to learn something and if you don't know where to put hands trusted only do damage and then leave it alone alientech you are a slave to them and you will never be operating not to mention the money that you are asking for...the first thing already? that parts from a theoretical basis ? very important then, once you read the file you'll know how and where to go to change given that not all of the items that you will find will be changed...

* ake85
if this was a response to my question, I believe that you do not understand my question.
I know how to identify the maps, and I have the knowledge to modofy them.

My question was different.
My question was if ? can move the maps from left to right so you can put them one above the other, so you can compare the versions of the software diffrent