From the tests I have done are convinced it is wrong the position in which the coloured wires are soldered to the pin 15 pin.
the use of wires, "instructions" included in the kit is as follows:
1：GREEN-CAN L
2：ORANGE-VKEY
3：YELLOW-K LINE
4：ORANGE-VKEY
5：RED-VECU
6：BLACK-GND
7：BLACK-GND
8：PURPLE-VPP
9：RED-VECU
10：WHITE-CAN H
11：BROWN-RESET
12：GRAY-BOOT
13：BLUE-CNF1
In my first attempt to use the Ktag, I realized that the red cables were not of the positive
I attach the pinout with the positions of the coloured wires as they are soldered on the cable 15 pins included in the kit and Ktag and Kess I purchased.
I have also written the voltages from the me measured at the outlet, Ktag (only allimentato jack 12V with central positive and external ground) on connector 15-pin.
I ask, if someone can tell me the positions of the colours of a known working cable.
sorry, but I have noticed a write error in the attachment:
in the measurement written down, with the tip negative to pin 13, the pin 11 has a voltage of about + 2.5 V (up to 12.8 as written)
Quote
