View The Full Version : identification software hardware bosch motronic
Hello all, I stumbled across something quite interesting and we also say to distraction, I had a ecu that I was using to test a Bosch Motronic I pulled his file and put it in the laptop then I had to move all the data in the fixed, almost can't find anymore, and I don't remember which version of software the file must be paired with this hardware code on the ecu 06A906018R - 0 261 204 673 where 673 and hardware for this type of ecu I know which mount only two types of software the 359591 or the 358109 (I know only because looking in a database gave me these data here, because the software code I have not been able to see it written somewhere on or inside the ecu) but as I said I don't remember between the two what is. If you can help me thank you very much
I do not understand you have lost the File or ID?
If you have the file in hexadecimal there is life, death and miracles..
If you don't post a photo of the ecu with the codes.. car cubic capacity etc..
basically, the file I lost it but I found on a site 2 original files there are two versions of this file, i.e. with the two software are different but the hardware is identical, my problem is that I don't remember which of the two files, that is, which software should be coupled with the ecu
VW golf 1.8 T 150HP 06A906018R 0261204673 358109
VW golf 1.8 T 150HP 06A906018R 0261204673 359591
only the hw can't find it, why, precisely, mount them all and two.
unfortunately, the flash that I extracted and then I did some tests and for me the question of which of the two software mounts, at most I try the first one and then the other if they work on the same hardware as I do not think there are problems
Also in the Mod file there are the info you need..
but there would be a separate program to extract this information? also because I do not think you say this file was coupled with such hardware may be wrong though, but riasalire the number of the software was originally beginning to think is impossible, or one of the two files with different software was only an update of that specific hardware
so I did this test I compared the two files with the ecm maps important management turbo injection and advances are identical, the only difference is the advance control of the minimum, in fact, I tried the file 359591 not always the car at the minimum sometimes tends to go up and down as the rally cars when they have the profiles of the cam are used, while with the file 358109 the car at the minimum and perfect. I think at this point to keep the 358109
Feel I'm not going to bring forward a post only to get the right numbers..
Now if you are not able to read the ECU contains a mod file ori etc., Which then also in the eprom are all the data that is needed and I close it here
Look, maybe you're wrong, I'm not here to make up the numbers, however, the only way that I know to read the data from the file and put them in winols and go into the project and have them give you the software and some other data, then if there are other methods I don't know them sincerely, if you tell me there is another way with this program maybe I understand better I see that is what I do not and never happened before.
you can identify the file by the button info to the ecm
hello thanks for the information, I knew that I was going to see them kind of as in the ecm of 2001 that in order to understand which driver to use, you had to know the 3 final numbers of hw and sw that makes the bean in the info, still not remembering which file was in the source between the two I had to try the first one and then the other.
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.