Wrong size MPC file

[pippo65]

As ever the Cockerel in writing bdm accepts me the only MPC file 513 kb?
It is possible to reduce the size of the MPC by 516 kb 513 ?
Thanks.

[pippo65]

In reality, if I remember correctly, the wing will accept them from 512kB.
The bdm100 and all its derivatives are reading the micro mpc555 from 516kB, while the cock in bdm reads 512, but it is the same thing, just cut off the last 4kB with a hex editor and you're set.

Then the Cock the mpc555 the create from 513 kb, with an editor type Winex can you tell me how to take it from 516 to 513 kb?

[pippo65]

It is very simple, open the file and scroll down to the end of the file, select starting from the end to recede, you need to select 3kB of data, then select cut or delete (depending on the program you use), and finally save the file.
Later in the work comparison of two files and tell you accurate up to that address you have to cut.

Thanks!!! you are very kind.

[pippo65]

Then, I can confirm that the file that accepts the cock is 513 kB, and you have to cut from 80100 to 80fff to reduce from 516kB to 513kB.

Ok Thanks.