siger96

hello to all!
I wanted to ask kindly if someone can tell me which interface I can read and write on the ecu this wv polo 1.2 12valvole 3-cylinder petrol CGPA of 2009, (the place the photo of the controller below). thanks.

cinqueturbo

What do you hope to achieve by mapping this car??
that interface you have at your disposal?
this manual shall be read in both serial and in the boot

danny677

Don't lose the time, the cv out is not pull out of this engine.

siger96

Hello, and thanks for the reply, I'm actually working on a project to transform it from the intake to the turbo, I have mpps v13 and I wanted to know if I can work on it or do I need some other interface, galletto or kess, you are a novice with the change of the control units and before any damage was done I wanted to ask advice thanks.

cinqueturbo

Hello, and thanks for the reply, I'm actually working on a project to transform it from the intake to the turbo, I have mpps v13 and I wanted to know if I can work on it or do I need some other interface, galletto or kess, you are a novice with the change of the control units and before any damage was done I wanted to ask advice thanks.

Mpps doesn't support it..

siger96

then what can I use?

cinqueturbo

Gallo2 Kess, K-tag, etc.

siger96

Thanks, being a beginner in the field what you recommend me?